This paticular ap must have gotten unplugged during the updating process after the initial.
Air cap3602i a k9 factory reset.
I want to do reset using hard reset but always fail do the steps in hard reset of cisco device are all the same can you give me the.
1 i tried holding the mode button then provide power to the access point and continue to hold mode button until i see an amber.
To reset a cisco router to factory default removing the startup configuration file perform these steps.
1 to erase the configuration file issue the erase nvram.
I can not get into terminal via serial port 2.
Connect to the access point with a serial console cable fire up putty and connect to the correct com port.
Open the hyperterminal and link the ap by console cable to com port.
Reload the router by.
Licensed premises radio stations and unlicensed specified low power radio stations used in factory production lines.
An existing access point running software release 5 2 or later has been reset after clearing the configuration.
Access points can be powered from the 48 vdc power module or from an in line power source.
The 1040 1130 1140 1240 1250 and 1260 access points support the ieee 802 3af power standard cisco pre standard poe protocol and cisco intelligent power management for in line power sources.
Plug the power cord while holding mode button until i see mode button pressed line.
I want to factory reset a cisco air cap3702i a k9 access point but can t figure out the mode button sequence.
This summer the it department at my location rolled out a little more than 100 air cap3502i a k9 s to much success.
I m fairly certain this will work with most aironet access points but i only have this model available.
Cisco air cap3602i e k9 ap factory reset hello i have to reset a lot of those aps to default settings and i d like to ask if i do it correctly.
I have a problem configuring cisco air cap2702i f k9 ap 1.
To factory reset a cisco air cap3502i e k9 follow the following.
We have had an issue with only one ap.